Garage Floor Paint

A garage floor with a like-new appearance can make a great lasting impression. With basic supplies and some elbow grease, you can make improvement in your garage to add value in just a couple of days.

These are few steps you need to follow before painting your garage.

Remove Oil and Grease Spots:

Before you power wash or paint/seal your garage floor, you’ll want to attack any oil, grease or rust spots.

  • Cover grease stains with a layer of sawdust or cat litter. These materials absorb excess oil remarkably well. Leave the sawdust or cat litter on the floor for at least one day.
  • Use a push broom with rigid bristles to sweep up the sawdust, cat litter and dirt.
  • Pour dry dishwasher detergent or a concrete cleaning agent on the stain. Let the detergent sit for 45 minutes, then pour boiling water on the area and vigorously scrub the stained section with the broom.
  • For stubborn stains, use muriatic acid in combination with your pressure washer set to at least 1200 PSI. Apply the acid according to the manufacturer’s instructions. Allow it to soak for a few seconds and rinse. Use baking soda on the cleaned area to neutralize the acid, and rinse.

Remove Rust Stains:

  • Combine an ounce of trisodium phosphate (TSP) in a gallon of hot water. Wet the concrete and use a push broom with rigid bristles to scrub. Let the solution soak into the concrete for 10 to 15 minutes. Rinse thoroughly

Fill the Cracks:

  • Small cracks can be filled with an epoxy paste. Once you’ve filled the crack, scrape excess epoxy so that it’s flush with the floor. After the repair dries completely, do some light sanding for a smooth finish.
  • For larger cracks, overfill with an epoxy paste. Let the repair dry. Then grind the area so it’s flush with the floor.

Prep the floor:

Moisture Test
If you think that moisture issues might prevent paint or sealer from bonding, here’s a simple way to find out: Cut out a 3-ft x 3-ft square of plastic sheeting and tape it down completely to your garage floor. If after a day or so, water collects on the underside of the plastic, you’ll need to put down a good vapor barrier before the primer coat.

  • Etching the Floor
    To etch the floor of your garage, apply a commercial concrete etcher, being careful to follow the manufacturer’s instructions. If the etcher fizzes up as it’s applied, you know that it’s working. Let the floor dry overnight. The concrete will now have a grainy texture, which offers a better surface for the paint to grip.

Seal the floor:

  • To prevent future staining, to minimize concrete dust, and to make it easier to sweep, you can seal your garage floor. If you are planning to also paint your garage floor, applying sealant can act as a primer. Priming prior to painting can help achieve better adhesion if moisture is an issue or if the concrete is dusty and “weak.”

Paint the Floor:

  • When selecting paint for your garage floor, make sure to choose an epoxy paint created especially for garage floors. Mix the paint well and apply a thin, even first coat. Cut in along the edges of your garage with a brush and then use a roller with a medium nap to apply the rest of the paint. Let the first coat dry thoroughly (about 24 hours).

Leave a Reply

Your email address will not be published. Required fields are marked *